What is the diff. Between rectangle & parallelogram?
- 10 Answers
- 29679 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
rectangle is staraight corner & Parallelogram is slightly
crossed corners
| Is This Answer Correct ? | 22 Yes | 17 No |
Post New Answer View All Answers
What is a hatch patterns?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
length where bent up is made in slab of bridge from one end
What are the different types of civil engineering?
What is Gsb tollens ?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
what is difference between NP2 NP3 NP4 CONCRETE HUME PIPES USED AT SITE
Can someone please be curing period of the following according to IS codes Column beam slab brick masonry raft found. and also tell how many hours/day
Explain soil analysis?
what quantities of work done in terms of sq.mts/day/ of 8hrs for each varpenter (shuttering) and Steel fitter in terms of Tonnes. For slabs, Columns etc.?
What is the standard rate of installing ties for column(60cmx60cm) and beams(50x850)(weight)
how we calculate the grade of the Bituminous materials.?????
how to workable concrete cube test M-25 design mix
What are the important hardware systems used for cad?
