Answer Posted / raj
To identify the creepage distance
* Define the installation category
* Define the degree of pollution expected
*From the nominal voltage and the type of supply system
select the rated voltage from table 00.03 a/b
*From the rated voltage and degree of pollution select
the minimum creepage required in table 00.04
For the dimensioning of the creepage distance the tracking
formation of the insulating material has to be considered.
If not indicated contrary, the CTI value of the insulating
material is <400 and the isolation group
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
Benifits of 3ph 4 wire metering over 3ph 3 wire
What is corkscrew rule?
What are the specifications for conducting earth leakage test as per IEC standard?
critically criticize the application of ring main unit in power system
What is the bundle conductor?
11 kV line deraction check by an Engineer.
What are the factors influence the choice of an electrc drive?
What is the end effect of linear induction motor ??
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
i completed my DEEE. and i want to electrical c license. how to get it..?
What are IR values and what it should be for coil and for insulator
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
Explain what are inter-poles and why they are required in a dc machine.
What is domestic transformer? Draw the connection of domestic transformer.
