What is the difference between induced draft and forced
draft fan? where are they used?
- 3 Answers
- 18107 Views
- I also Faced
- E-Mail Answers
Answer Posted / ujjwal koley
ID fan maens induce draft fan & FD fan is froce draft
fan.both are use in thermal power plant/ Sinter Plant.ID
fan so connected the airpreheater.fd fan is so connect the
eletropre-preted.It used in Blast Furnace also.
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
any one have amw(ASIAN MOTOR WORKS) QUESTION PAPERS OF PREVIOUS PLS SEND ME AT mahendra_yalavarthi@yahoo.com
Proximity analysis of coal provides data for a first, general assessment of a coal’s quality and type. What elements it reports ?
What is gd&t?
What should be done to prevent a safety valve to stick to its seat ?
22216 CC bearing
Where do you put the oil in a compressor?
What is the difference between Mild Steel and Cast Steel with full chemical composition and application details.
why does polytropic efficiency of a compressor decrease with increasing flow rate ?
What is critical pressure ?. What will happen if water is heated above critical pressure and temperature?. What importance it is having related to Boiler?. Upto what presrure natural circulation is possible in Boilers?.
Is it required slip & guide for incliened pipe installation to allow axial expansion. If yes, what type we have to use it
Why is thick steel wire stronger than thin steel wire?
hi friends kumar here if anybody of u have " INDRAPRASTHA GAS LIMITED" placement papers than plz send it to me i need it urgently..ok mail id is ashish_me2007@yahoo.co.in
How would you increase the volume efficiency of centrifugal pump?
What are the causes of damage of diesel engine exhaust Valve?
what is fullform of ge 9ea gas turbine
