why the voltage level in transmission line are in multiple
of 11kV, 22kV, 33 kV etc..( i.e., 220 V )?
- 4 Answers
- 7325 Views
- I also Faced
- E-Mail Answers
Answer Posted / swapnil
it includes an allowance of 10% for line drop
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
what is the reqirred voltage in HT motor to get full RPM on no load test?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
Define unilateral circuit?
how many parameters can integrate with fire alarm basically ?
Differentiate between low pass, high pass and band pass filter?
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
1.what is the reason for transformer and lightning arrester blast in 33kv system
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
what is PDU in transformer?? which company manufacture??
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
What we mean by vintage of an engine+Generator?
What are the different types of hydro schemes?
