Answer Posted / anish kumaran.r
Mass flow is nothing but steam flow. If we need to convert it in to volumetric flow need to divide mass flow by density.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
how to design orifice plate?what is the equation?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
what is the process for double acting cylinder pneumatic for 32' v/v
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what does it mean an active front end in vfd plz explain it briefly
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
How to work temperature gauge?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
What are the types of control valves available
how is work pressure switch& level switch?what is the principle of this?
how the arrangement of equipments done in control room
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
