Interested to Buy Any Domain ? << Click Here >> for more details...
how can we measure the level measurement with the help of
pressure gauge?
- 7 Answers
- 14248 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / anish kumaran.r
Using purge tube method you can measure the level by a PG and a air regulator. But it needs suppy air. Make a 'T' setup and connect gauge at one end ,supply air at one end and another end should be inserted in to the tank where the level to be measured. The gauge shows t level of the tank we shd convert into mmwc.
Regards,
R.Anish kumaran,
C&I Engineer,
Thermax ltd.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Explain an adaptive / self-tuning controller’s major draw card.
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What is modbus?
How many interlocks at turbine? Plz explain briefly
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
How oil line flow measured?eplain about instruments used and working principle?
What is the difference between ff transmitter and non ff transmitter
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
How will you calibrate PID controller? explain with example.
what is difference between HOT permit and cold permit
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
How d.p. Transmitter can be applied to close tank?
