why Flywheel is used (Need technical answer)? why generally
flywheel is big in shape?
- 8 Answers
- 23129 Views
- Ford, HCL, I also Faced
- E-Mail Answers
Answer Posted / kapil
flywheel is used to store the energy and supply it when there is a variation in speed,like in IC engines where the 3 strokes other than power stroke are idle strokes...
energy stored in fly wheel is directly proportional to the moment of inertia i.e I=mk^2.
where m=mass of fly wheel.
k=radius of gyration(i.e radius of flywheel)
if k value is high, amount of energy stored vll be high, so obviously size of the flywheel vll be big.
| Is This Answer Correct ? | 25 Yes | 0 No |
Post New Answer View All Answers
can i use IS 2062 gr B pipes in the softening plant pipings?
What was the spinning jenny?
current rating of a 3 phase dg set is 20 amp, but what will be the per phase current for single phase supply?
why boiler is closed system ?
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
how long normally does the domestic refrigerant capillary tube are?
how you can define coal ?
diffuser increases pressure but in turbine pressure is decreasing when steam passing through casing?
Explain in an orderly manner how the force in the member of a truss be detected using the method of joint.
What is the congressional space medal of honor?
How is martensite structure formed in steel?
What is forced convection?
What is the difference between Muff Coupling and Screwed Coupling with Cotter pin used in pump line shafts.
Explain the types of sensors.
What are safety considerations in welding job?
