1. which type of transformer connection is preferred in
case of power supply transformers?
(A) Star/Star
(B) Delta/Delta
(C) Star/Delta
(D) Zig Zag/Star
2. In a power transformer usuall which winding is closer to
the core?
(A) Primary winding
(B) Secondary winding
(C) Low Voltage winding
(D) High Voltage winding
3. The power factor of a purely inductive load is
(A) Zero
(B) Lagging
(C) Leading
(D) Unity.
Answer Posted / gaurav agarwal
1. star/delta
2. secondary winding
Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
in non technical way how can u define POWER FACTOR??
how does a shunt reactor maintains the bus voltage???
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
pre arcing time of ehv breaker
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
how to calculation increase power factor for single phase
where reactive power is used
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
state the disadvantages of carbon filament???
why should the primary of transformer be connected in delta in a heat run test?
Inverter. converter. Ups.MCB.solar.alternators. motors.
Why is the starting current high in dc motor?
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
what are the disadvantages in GIS over AIS