Answer Posted / laxmialn
copper losses depends on current and iron losses depending
upon voltage.The total losses are depending on current and
voltage only .power factor is not come into picture
here .thats why transformer rating is in KVA not KW
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
Post possible questions for Power Factor Panel FAT / SAT
How to design the NGR Resistance
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
What is the difference between line drop and percentage line drop?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
what is current check gurd relay?
How are load losses and no-load losses measured at site in a DG set?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
How to operate a ac chilar plant?
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
Pl. share your experience about industrial-electronics repair of machine tool.
what is the common earth
