different between twostroke engine foure stroke engine
- 3 Answers
- 7124 Views
- I also Faced
- E-Mail Answers
Answer Posted / sujay saha ( lecturer of n.h.i
1. Thermodynamic Cycle is completed in 2 revolution of the
crankshaft for 4 stroke engine where as this cycle is
completed in one revolution of the crank shaft for 2 stroke
engine.
2.Turning moment diagram is not so uniformlike 2 stroke
engine for that reason heavier flywheel is required for 4
stroke engine.
3. Volumetric efficiency is more than 2 stroke engine.
4. Thermal efficiency is higher than the 2 stroke engine.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Which minerals are used in the manufacture of cars?
i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam
Tell me the difference between torque and power?
Why oil with petrol can be used in two stroke engines but not in four stroke engines (two wheelers)?
What are sliding contact bearings?
The crown wheel of the final drive is connected to a) Cage b) Spider c) Cross pin d) Axle half shaft
Explain the consequences of using bs3 engine fuel with bs4 engines.
what is the syllabus for the rrb sec. eng. posts iam from automobile engg.
What is reciprocating air compressors.
What is the difference between bs2 & bs3 engine?
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!
1.what is the minimum percentage for engineering students? I like to become RTO officier...please send me procedure for that...
What is bearing and what are the different types of bearing ?
Double declutching is used for the engagement of gears in a) Sliding mesh type of gear box b) Constant mesh type of gear box c) Synchromesh type of gear box d) None of the above
