What is the difference between RMS and average value
- 5 Answers
- 36441 Views
- CEERI, HPCL, I also Faced
- E-Mail Answers
Answer Posted / waqas
RMS value is Root of mean of the square of a sinusoidal signals instantaneous value.
Average value is sum of negative and positive side of a DC signal wave.
Average value for AC signal is always zero because half cycle of sinusoidal is +ve And half cycle is -ve so its sum will always be zero
| Is This Answer Correct ? | 16 Yes | 12 No |
Post New Answer View All Answers
what is consequences of neutral and earth connect?
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
how to find three phase complex power in per unit and MVA?
What is contract demand in solar system?
Alternator rotor earth fault relay circuit
What is different bewteen low or high impedance busbar protection scheme
why i can not use thimble on capacitor duty contactor
How can find thermal state value in relay for calculate thermal overload.
How the capacitance og capacitor volatage transformer is decided?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
pre arcing time of ehv breaker
can i connect wavetrap in 2 different phase in EHV line?
You are of electrical field and you are going for software? Why
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
