which connection is safer series or parallel?usually which
connection we prefer at home?
- 5 Answers
- 8337 Views
- I also Faced
- E-Mail Answers
Answer Posted / k mohana krishna
parallel connection is the best connection in my opinion.
because in series one of the bulb get fused off the total house supply fail, where as in parallel only that bulb will effect.
| Is This Answer Correct ? | 17 Yes | 0 No |
Post New Answer View All Answers
what are the factors to be considered while design the breaker either HT or LT??
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
Load break swicth maintenance procedure.
What is the diffrence (Technical & Construction ) between CBCT & Normal CT?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
How out of step protection relay works?
Sir, plz tell me how droop setting is done in parellel operation od DG set ? please give practical example ?
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
What are your future plans for the company if permanently employed?
How Diesel Generator start ?
What is the principal of motor?
Why we are going for converter transformers for DC drives application instead of distribution transformer?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
