What is the differences in phase to phase voltages between
star and delta connections of stator?
- 1 Answers
- 4466 Views
- I also Faced
- E-Mail Answers
Answer Posted / md zakeer hussain
In star connected stator the line voltage is equal to
1.7321 times the phase voltage, but in case of the Delta
connected stator the line voltage is equal to phase voltage
as we done the calculation of poly phase balanced and
unbalanced networks.
the relation between the phase voltage in star connecred
stator to delta connected stator is,
Delta connection: Vline = Vphase ------(1)
Star connection: Vline = 1.7321 X Vphase-----(2)
from equation (1) & (2)
Vph(Delta) = 1.7321 X Vph(Star)
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
what is meant by 2 within a star in a voltmeter dial?
Why Stabilising Resistor used in REF circuit ?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
Define bibo stability.
Why GRR starts from 60% of motor speed why not less than 60%?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
What is the test block protection relay if any body know plz explained
List advantges of active filter over passive filter?
how to calculate short circuit current for the busbar
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
what kinds of Transformer oil grade is better for power transformer ?
