what is the difference between two way slab and flat slab?
what is the benifits of flat slab?
Answer Posted / suraj
1-In two way slab, the slab is supported by beams, the load
of both slab and beams is conveyed to columns and footings.
Flat slab, or more accurately flat plate the slab is
supported by columns, no beams to be used.
2-In two way slab,shear is critical in beams and considered
in slab.
Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
How to Calculate Materials Required for PCC 1:4:8 for 1Cum & Brickwork 1:4 for 1Cum & Plastering 1:4 (15mm Thick) for 100Sqm & RCC 1:4:8 & 2mt ( L1=1mt & L2=1mt ) length of 12mm Steel bended in 90degrees what is the formula to calculate Weight & Actual Length ?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
CAN WORK WELL UNDER DEAD LINES OR PRESSURE?
Material calculation of cm 1:6 for 1sqm
What goals do you have in your career?
kindly mail me by attaching files , formats for quality checks of common building materials like cement , concrete , bricks , sand and aggregates plz send my email id- VMANDAL91@gmail.com
What is the Maximum %age of Steel in columns and beams ?
How to use of me trial wall plaster 6mm , 10mm par sqm. use in sand and cement ?
What is the quantity of cement used for stone pitching work of 100sqm 225mm thick and cement mortar of 1:6? And how?
if we use 1.25 bag of cement 3 pharma metal and 2 pharma crush sand what is the strenghtexpected for RCC column
How do you compute volume of airflow?
what radial pressure, the NP2 class rcc pipe can sustain?
50 acre of land to be reclaimed for an average height of 2.5 mt. Dredging area is 500mx200m size. what is the dredging depth required to reclaim the area?
What is Gsb tollens ?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.