Interested to Buy Any Domain ? << Click Here >> for more details...
What is the d/f between DOL & star delta starter & automatic
star delta starter?
- 23 Answers
- 165505 Views
- ACC, Dalkia, Engineering, Indeco, NINL, Novotel, RMH Control Systems, Wipro, I also Faced
- E-Mail Answers
Answer Posted / rajendra mallick
In a DOL starter motor terminals is directly connected to
starter such that initially a very high starting current is
feed to drive the motor.Dol starter is used for small
motors below 5hp because of high starting current may
damage motor winding. Dol starter using for large motor
using star delta connection,first motor run on star
connection mode upto 80% which provide low starting current
and low torque initally and after getting maximum torgue
motor operates on delta mode with high torgue.
| Is This Answer Correct ? | 25 Yes | 6 No |
Post New Answer View All Answers
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What is the type of earth fault protection used in battery? explain.
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
How to calculate impedance volt in Transformer?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
can u give me a brief idea about power line carrier communication ??
What is routh hurwitz stability criterion?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
What is step signal?
What is mason's gain formula?
hello if any one have papers vof hpcl or sail, plz send me
