what is the ratio of young's modulus of elasticity for a
mild steel specimen in tension and compression?
- 7 Answers
- 12749 Views
- CCCL, I also Faced
- E-Mail Answers
Answer Posted / arvind
0.45fck in compression
| Is This Answer Correct ? | 7 Yes | 6 No |
Post New Answer View All Answers
need to join coaching institute in coimbatore tamilnadu ......say me the best coaching for IAS
How to calculate thickness of MAT slab & Reinforcement? The dimention of under ground water reservoir is 80'X14'X 12 ft
can any one tell me in detail footing estimation .. i am new here in dubai so facing lots of problem...
TO CONSTRUCT A 1800 SQFT CAPACITY UNDERGROUND WATER TANK HOW MUCH CUFT CONCRETE IS REQUIRED AND HOW MUCH REINFORCEMENT IS REQUIRED. FOR COSTING
What is the primary difference between adsorption and absorption?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
WHAT IS YOUR CURRENT SALARY
What is the ideal size of the living room ranges from small to large size?
Explain major differences between routing maintenance and major maintenance.
WHAT R THE GENERAL TECH QUESTIONS ASKED FOR THE INTERVIEW FOR AN AUTOMOBILE INDUSTRY,SPECIALLY DESIGN DEPT
Gidc technical que paper
Who name us Engineer & Why?
How to find permissible diagonal tensile stress in reinforced brick work
