why need to be maintain power factor for industrial
customer?
- 2 Answers
- 4090 Views
- I also Faced
- E-Mail Answers
Answer Posted / raja
If power factor is decrease means the power consumption on particular equipment is increase. Thats only industries are maintain high power factor
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
What are dcs and plc?
why genarator genarating voltage 11 KV?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
Why we use circular(Stepped) cross section in transformer core?
Explain using drawings what is reverse PID action w.r.t PID controllers.
how to remover corona effect and hysteresis losses from contactor
lenz law application and define
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
Refernce currents are to be generated using refernce cueernts how can this be done??
why use phase displacement in transformer.and effect of phase displacement on transformer
What is the high series capacitance winding on high voltage power transformer ?
Why 3 phase induction motor getting supply in body if one of it's phase is cut
