How can we configure Inter-VLAN in Layer 3 Switch? Remember one thing without Router.
- 7 Answers
- 10234 Views
- Grace, HCL, I also Faced
- E-Mail Answers
Answer Posted / vikram
intervlan routing can be configured by using layer 3 switch
. enable SVI interfaces and ur layer 3 switch will start
routin packets .
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is the draw back of ospf protocol?
Name the protocol which can do load balancing on unequal cost also?
What metric does rip use? How is the metric used to indicate an unreachable network?
Define osi?
When we use loop back ip?
How network gateway is different from routers?
What does the show protocol display?
Which mode called privilege mode?
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
What are 10baset ethernet lans?
Briefly explain the conversion steps in data encapsulation.
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
How many (minimum and maximum) ports are present in a router?
What does routing mean?
In port based access-list which command u give instead of ip?
