what is tan delta measurement?..... why that terminal is
earthed.....?
Answer Posted / raul
tan delta testing is done to measure the dielectric
strength of the insulation.........n to determine whether
the insulation is in healthy condition or not.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How can we increase fuel-power ratio of any DG set?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design
What is signal flow graph?
what are the sample questions asking to the test cunducting for electrical superwising lisence test?
what is the excess air in furnace
Why are iron cores in transformers made laminated?
How to check the cable fault / hv test of transformer cable.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
what is the significance of tan&delta and how it performed in power transformer
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
WITCH CARDS IN USE IN FIRE CONTROL PANEL.
i am studying in final year can i allowed for 23rd UES of Indian army
what is lumped and distributed elements?