Answer Posted / parth patel
when we install any new transformer we have only load
current as known quantity accordingly the secondary voltage
is selected. but we dont know which type of load will be
connected on the secondary side it may be inductive ,
capacitive , resistive or combination of them.So as we dont
know about the load we dont know power factor of the load
thats why the ratings of transformer is in kva and not in
kw.
Is This Answer Correct ? | 11 Yes | 13 No |
Post New Answer View All Answers
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
what will happen if synchronous machine rotor fed from single phase ac supply
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
what are pilot cells
i applied for the ap transco please forward the freqventley asked QA
what is advertised hop count
How can we checked Killo Watts of Motor & Alternator?
why star point of HT motor not earthed?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
how to calculate the size of the HT cable
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
What is the control action?