Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between MCCB & ACB & VCB
- 4 Answers
- 9483 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rsundareee
MCCB-moulded case circuit breaker,
ACB-Air circuit breaker,
VCB-vacuum circuit breaker,
MCCB - We can use up to 800A in low voltage side(LV)
ACB - We can use From 800A and above in low voltage side
(LV)
VCB -We can use HV side only,It is all the diff kind of
application and design
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the purpose of stand by earth fault protection for transformer ?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
why does a dc machine has high efficiency while working as a generator than as a motor ..
how is working bearing heater?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
Is neutral transformer can be called as control transformer?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
is that any software calculator to calculate the size of cable
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
