Answer Posted / asg
Voltage is one of the Electric pressure between two ends
like high potential to low potential. Current is a flow of
electron move from one end to another end by the pressing
of volatage.
Is This Answer Correct ? | 17 Yes | 6 No |
Post New Answer View All Answers
What is the working principle of servo motor? And explain it.
What is the types of HT motor testing
What are protections for dty type transformers
What is the formula to calculate the rating of power cable for three phase current.
What is meant by stator? What is meant by rotor?
How to calculate the size of earth cable to earth the neutral of UPS ?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
is there any current and voltage drop on liquid resistance starter water/soda tank ?
Safety of dry type transformer
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
In a single how much maximum current and watts using