In a transformer, the hysteresis and eddy current losses
depend upon
1.load current
2.maximum flux density in core
3.type of lamination
4.supply frequency
The correct statements are
(a) 1 and 3 (b) 2 and 3
(c) 1 and 4 (d) 2 and 4
- 9 Answers
- 10882 Views
- I also Faced
- E-Mail Answers
Answer Posted / nareshkumar_1225
d
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
Why mostly the HV side of transformer has Delta?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
Define phase cross over?
what is the difference between ups & inverter
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
how can motor both beasrings insulation resistance can be check?
What are the classifications of heating element?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
what are the different methods for the starting of a synchronous motor.
why we use single core 630mm2 cable for transformer secondary side
What is stacking factor? What is its approximate value?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
