how can we measure the level measurement with the help of
pressure gauge?
- 7 Answers
- 12135 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / satish tumbare
above answer is not write.Density also affect level
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
Why even multiple power supplu r used in instrumentation system?
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
i want to find out iffco get test paper
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
What is the diffrence between ff tx and non ff tx
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
Galvanizing.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What is stripper & spilitter ? Diffrence in this.?
what is the imbustion control loop
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is super thermocoupal?
give me all the details about the interview and which type of question being asked
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
