Interested to Buy Any Domain ? << Click Here >> for more details...
What is transformer tap changers please explain
- 3 Answers
- 9819 Views
- Feedback Venture, Sail, I also Faced
- E-Mail Answers
Answer Posted / byd
i am working at Transformer factory as test engineer, tap
changer is the part of transformer's primary winding which
is use to balance secondary voltage, for example we
have transformer which feature are: 630kva, 33/0,400 kv,
and this transformer has a tap changer , transformer
primary voltage positions are like these
HV(v) Lv (v)
28500
30000
31500
33000 ....... 400 v
34500
36000
network voltage is 33000v but sometimes it can be
increase or decrease , you can change tap changer:)
but this for no-load tap changer for distrubition
ransformer, if it is power transformer you should use
load tap changer
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
how to check regenerative load in drived motor
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
Which power will flow first if we switch on a motor Active or Reactive? How?
How many types are using in 220kv/400 kv swith yard
What is Faraday's law
how was your last weekend.
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What are the conditions for sustained oscillator or what is backhouse criterion?
how to find the resistance and gap volatage of the diode??
what is the role and fuction of automatic transfer switch in rotary ups
what are the pecularity of shaver sockets ?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
