Answer Posted / venkatesh.m
molded case circuit breaker
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
What are the advantages of speed control using thyristor?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
state the disadvantages of carbon filament???
why the rotor current becomes in steady state during high slip region? please verify with equations.
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
what happens to the supply voltage if there is any change in frequency?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
how to identify conection leads of an unknown electric motor
Why generation voltage in thermal power plant is between 11kv to 33kv?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
How the over load setting for HT Motors calculated-provided in Numerical Relay
