How the flow can be measured by using DP Transmitter?
- 3 Answers
- 8493 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish namdev, bina refinery [
A DP type transmitter senses DP pressure from LP & HP tapping.
after sensing DP we will have to change some settings in the
transmitter, the settings are as follows -
1. set the range in output block.
2. change display parameter from linear to square root.
3. change display unit as per your requirement.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
where cascade loop use ?
what are the values of fuel flow rate in various places in boiler.
if my flow is 20000 m3/h than which range of DPT i have to use????
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
what is diffrance between FF & SMART, explain with difination
steps for installing orifice plate?
why we take %i0.0 as input for twido plc
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
What is the basic difference between Modbus and CAN Open Protocols
