Answer Posted / bhupesh pal
Valve Positioner Behaves like a control loop,It measure the
previous position of the stem of the control valve and
according to the new i/p (4-20 mA)adjust the new position
of the Stem of the contol valve.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
HOW TO CHOOSE FREAQUENCY IN FMCW TYPE RADAR INSTRUMENTS. DESIGN BASIS OR DESIGN CALCULATONS ?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
Gas equation
State some of balance principle’ advantages?
What is the principle of capacitance type level transmitter?
what is the difference between scaler and vector drive
define feed forward control loop with example and drawing?
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
How to find out the current of two motors having same power consumption but different RPM?
What are de-saturators?
How to Calibrate Level Switch in field
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
How the warning lamp of a charging-system is activated ?
