Answer Posted / mahesh somarowthu
current is a flow of charge carriers
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the commonly used schemes for the bus zone protection?
what is the difference between earthing and unearth
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
how to setting voltage RTCC panel
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
What are the properties of a resistor?
Is MEN and RCD related to each other ?? IF yes then how??
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
What are the classifications of oscillators?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
Why High voltage are generate noise ?
What is non-minimum phase transfer function?
bus bar design conditions and sizing pls tell me quickly
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
