How to identify 3 phases of 3 phase supply irrespective of
there color????
Answer Posted / dharmans
step-1-: the three phases of alternator connect to the
primary of which is our auxiliary transformer then the
output is connect to the LT bus which is have 440v rated.
then connect to a 3phase motor through a breaker or rated MCB.
step-2-: now observe the rotating direction from the drive
end side of the motor. if the motor rotating to
anti-clockwise direction the connection of cable color code
is R,Y and B. if the motor rotating to clockwise direction
of the cable color code is Y,B and R.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
CBCT selection
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
Advantage of LT panel vs HT panel
What do you understand by oldham's coupling ?
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
what is the minimum voltage require to injure our body?
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
What is the formula to calculate the size of Aluminium and copper cable?
What is DTR erection?
How can we findout the maximum efficiancy of Transformer? At which load?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
11000volt DG set carnt kaise banvay
what is lrs tank water resistance.
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
What is the types of HT motor testing