Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ehtsam talat
DP & flow relation is non linear that is why square root is
used.it actually makes this relationship linear.
Q=10 under root Dp
Q=flow is %
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
Which language of programing is popular? how can i learn it ?
Describe the function of Accumulator into the Pump
Draw symbols of the following :
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
Give Detail information about plc,dcs,and scada system?
Why are the uses 24vdc in industries
What is 3 element control system
What is eddy current? Describe the operating principle of proximity probe.
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
what is the difference between -24 : +24 & 0:24 and where it use?
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
Why grounding is necessary? Give example with diagram.
In apron feeder how TPH is calculated?
what is exact time to study dcs and plc cources
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
