Answer Posted / vinayakamoorthy.k
Conditions for syn.DG
1.Voltage must to be same
2.Frequency must to be same
3.Phase angle must to be same...
If the above three conditions are correct then u can
syncronise our DG set one by one...
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
grr resistance & contrator malt continuous
can we use trip light with bus coupler?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
how we decide the require size is this for a known current at fuu load?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
how can i change the rotation of the AC single phase induction motor and show me by diagram
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
what are the problems that generally occur in power flows??
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
How to calulate Locked rotor amper(LRA) for compressor type motors?
Which Class insulation is prefered for the sandwich Busducts ? Why?
Define coil span?
Make a list observation on Transformer?
