Answer Posted / md. nazmul hossain
s(t)= Ac[1+kam(t)] cos(2*pi*fct)
power of carrier component: Ac2/2
power of message component: ka*m*Ac2/2
total power: Ac^2[1+ka^2*P]/2
where P is the power of the message signal.
As there is no option of subscript and superscript, it is
very difficult to write mathematical equation.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
In Traffic Manager, What is the Use for Zero (0) timeslot.
how does a soft starter works
i am preparing for aai atc ? plz can u send me som emodel qus?
what is the difference bet 4 wire transmiiters and 2 wire transmitters
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
what is the universal communication protocol?
i want the aptitude test papers of wipro can any one help plz
plz send the rrb junior engg and assistant loco pilot previous quastion papers
What is q-factor of the coil?
sir i want to know when is the exam in 2009 and last date for application form ,plz let me know sir
What is the difference between the bandwidth of half duplex and simplex transmission?
what is amplifier?
What is the purpose of bleeder resistance in a rectifier circuit using l-c filter?
what is an operational amplifier?
What is snooping cache?
