why we use capacitor in Fans not resistor?
- 4 Answers
- 7459 Views
- Vardhman, I also Faced
- E-Mail Answers
Answer Posted / yk
we use capacitor not resistor b'couse in short for phase
difference in starting winding and running winding flux .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
What are the different types of dams?
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
previous year paper of ntpc bhel for degree in electrical enng
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
Explain what are inter-poles and why they are required in a dc machine.
how to failure indution motor insulation & how to improve heat in motor insulation
How many devices can be connected in one zone of FACP
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
How it can worked plc based electrical system And which type of software using.
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
Explain what cmos is and its benefits?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
