Interested to Buy Any Domain ? << Click Here >> for more details...
if the power factor is .88 i want to increase the power
factor to .99 what number of capacitor is to add?
- 3 Answers
- 6848 Views
- Amway, I also Faced
- E-Mail Answers
Answer Posted / sakthi
.540 x kw = ---kva
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What is mean by hot and cold loop testing?
what is distribution board?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
explain the Trip supervision circuit
What is contract demand in solar system?
I have 2500KVA transformer delta/star,13.8KV/380V provided with LV 4000A breaker. Already I have 2300KW motor feeder with a full load 90%. Is it possible to connect another 1600A from that breaker? If so how the calculation is done?
What does the kvar means?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
can we synchronize star system generators with delta system transmission line ? and how ?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is a system?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
