why phase to phase voltage are 290 rather then 440?
- 1 Answers
- 4394 Views
- Bosch, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Probably due to neutral shifting.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
What are the necessary components of the feedback control system?
What is lc oscillator?
Why can't we parallel the secondary circuits of two voltage transformers?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
what is the cause of voltage dipp or swell in the transmission lines?
How to Calculate KA Rating of Main LT Panel
What are the conditions for sustained oscillator or what is backhouse criterion?
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
What is the earth treantment procedure?
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
operation of diesel generator
