1.In two wattmeter method if one wattmeter shows Negative
reading then wat is reason?
2.Wat is the reason for low voltage in houses?
3.Wat is meant by current and voltage? wat is difference
between the two?
- 10 Answers
- 62023 Views
- Engineering, I also Faced
- E-Mail Answers
Answer Posted / dileep
two watt meter method is used in measurement of power under un balanced condition.there are two reasons for - ve value
1). if load consist of more inductivd or capacive load with negligible resistive then it will show _ve value .pf angle is more than 65 deg
. in case of induction motor no load test one of the watt meter will indicate _ve because no load pf is 0.2 lag pf angle is nearer to 75 deg
2).reverse. connections of current coil
| Is This Answer Correct ? | 98 Yes | 6 No |
Post New Answer View All Answers
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Why you want to join non technical field when you are an engineer?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
How will be the single line diagram of series trip HT breaker? how it works?
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
How efficiency of thermal plant can be improved?
Advantage of LT panel vs HT panel
how we calculate the short circuit capacity of the busbar in LV & HT?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
Which motor will you choose which can operate in both lagging as well as leading power factors?
Anyone who can recommend an equivalent to Envirotemp FR3 of Cooper?
how the phase convertor changes the no. of phases
