What is loop or pigtail in an impulse line?
Answer Posted / sreekanth
Friends....Pigtail is used only for protection of
instrument from temperature.
For pressure Damping we will use Pulsation Dampners.
Due to the loop, condensate is formed in the pigtail and
some part of fluid cannot be drained and remain in the
pigtail which will prevent the instrument all the time from
temperature from direct contact of the fluid.
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
How to calculate mmwc values into tonnes?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
Explain operation of Haskel pump.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What are different types of orifice plates? State their uses.
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
Why ac supply load cell is used? Can we use the dc supply load cell?
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
how many types of spped sensors n vibration sensors?their basic principle n connection?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
How many types of sensor
How d.p. Transmitter can be applied to close tank?