How to calculate meter constant @ HT yard
Answer Posted / debaraj das
It depends on your building CD/MD base on that EB will fix
there Meter M/F .Other than that you need to check with EB
Electrical Engg.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
CBCT selection
What is the power factor of an alternator at no load?
What is EMC filter in VVVF Drive ?
What facility we get after CT secondary earthing and how?
what is negative d.c. voltage, why this voltage is used in base transciever station.
how can i apilly for electrical c licencese.sir,i completed B.Tech in electrical & electronics engineering in 201onot working any company
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
Why do we use center tap transformer that used with portable tools
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
two way ckt diagram can be drawn by how many ways? give diagram
State ohm’s law?
The series field winding has low resistance while the shunt field winding has high resistance. Why?
What is the previous name of Cox's Bazar
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
How to calculate the electrical load for a standard telecom BTS shelter and choose the DG set capacity for the same load?