Do you know differenence between design mix and nominal
mix?
- 8 Answers
- 24967 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / pandey u. p.
The volume based proportion of mix like 1:2:4, 1:1.5:3 and
1:1:2 are the nominal mix.
When ever pre design strength of mortor is required then we
should go for design mix which is based on different
proportion of material by weight and several material tests
to obtained required strength by trial and error method.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
i have span of 6m x 4m how do i calculate the reinforcement of steel i needed and to at what distance and also the thickness of slab. looking forward thank you RAVI
I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,
How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.
what is BPM in concrete demolition hammers. what is better a higher value or lower
how to prepare site mix design
Critical Path Method is...
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
cause of cylinder test failure
Define What is passive earth pressure ?
How do you change a dimension value in solidsworks?
If u want ur Ans.Of any Question so mail me skatiyar011@yahoo.in
What is thumb rule in quantity and cost estimation of a residential building in civil engineering??
what is the use of beam end forces while using a staad ? wha they are show
what post do you prefer to work in this company and why do you think you can serve better in such position?
Does degree of bend of rebars has any effect on strength of the member? For example- if a beam is designed with 45 degree bent up bar with respect to architechtural needs and is not 45 in practical so will there be any reduction in the strength of member?
