what is the significance of KV & MVA rating of the
transformer and how they are related.
- 8 Answers
- 79691 Views
- I also Faced
- E-Mail Answers
Answer Posted / subra
In power transmission operating voltage are in K V
ie Kilo Volt
The transformers Capacity is in MVA ie Mega Volt Ampere
In power Distribution Network operating Voltage in KV kilo Volt
The transformer Capacity in KVA
Power in 3h = Root3 VxI ---VA
root 3VxI Cosphi----Watts
watts X 1000 =KW VA x 1000 = KVA
Watts x 1000000 = MW KVA X 1000 = MVA
| Is This Answer Correct ? | 93 Yes | 16 No |
Post New Answer View All Answers
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
how give earthing conection to household equipment?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
any one can explain the stages of a knee point which is taken during ct magnetising curve.
Air refrigeration cycle works on the
Define availability (operational)?
Is Transol transformer oil comparable to nynas nytro libra?
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
Name the types of motors used in vacuum cleaners, phonographic appliances, vending machines,refrigerators, rolling mills, lathes, power factor improvement and cranes.
WHAT R THE SAFETIES IN A HIGH TENSION PANEL N LOW TENSION PANEL. ALSO WAT SAFETIES R THERE IN A 200 KVA TRANSFORMER?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
why should the primary of transformer be connected in delta in a heat run test?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
