Interested to Buy Any Domain ? << Click Here >> for more details...
ELCP USE IN 3 PHASE SUBMERSIBLE PUMP? THEN USE 3 POLE 0R 4 POLE?
- 4 Answers
- 7759 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If only you had used the word ELCB instead of ELCP,you would
have got the answer long back.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
given data are load current & power factor cable core size? plz any one update the calculation formula
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
what is the relation between size of the anteena and wavelenghth of radiated wave
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
Why collecting electrode of ESP to be earthed
what reactive how to maintain
What is the practical way to calculate the cable size for known ampere load?
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
how the B-H loop obtain under the static condition
What are the factors which influence the choice of specific magnetic and electric loadings of a synchronous machine?
