Answer Posted / muhammad ashraf
KW is actual power and KVA is apperant power, all
transfomers and alternators are design at KVA bases and all
motors are design at KW bases. we can calculate the power
factor by using both.
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
1.why are not using acb 33kv ht side? is there any problem 2.what is difference between acb,vcb,sf6 breackers? 3.what is the function of invertor and convertor in ups?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
What is meant by impedance? difference between high & low impedance ?
how could we calculate the no of outgoings from a 800 watt distribution board
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
Mention what are the types of semi-conductors?
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
what is transient voltage?
what can be the causes of capacitor start motor having a higher current that its actual
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
can someone explain that how the speed of the protection system affects the fault level calculation?
Define non-touching loop.
What is the power factor of a transformer at no load?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
why there using acb enclosure in big buildings
