Interested to Buy Any Domain ? << Click Here >> for more details...
During he starting up of the motor, the upstream's MCCB
(350A) always trips due to the UVT relay activated.
Can Star-delta starter use for a 20kW Motor (For a powder
mixer machine) cause voltage-dip in the supply line voltage?
If so, what are the recommended solution to
eliminate/reduce the transient voltage dip in the line
voltage?
- 4 Answers
- 6981 Views
- I also Faced
- E-Mail Answers
Answer Posted / abdulsubur
upto 35kw motor u can use star delta
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
how to calculate the tarriff for an industry whose kva demand is 10 mva
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
what is consequences of neutral and earth connect?
lorteny method
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
What is creepage distance..... what will be the value for different voltage level
use of choke in APFC panels
what is the write prosidure of stringing of 8meter pcc pole.
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
