is any standard angle for thermowell mounting for
horizontal and vertical pipe lines?
- 3 Answers
- 9977 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandramauli sinh
Manufacturer recommends that it shall be 90 degree to the
pipe, and also recommends that its can be 45 degree facing
towards the direction of the flow.
Check the manufacturer recommendation and the fluid.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In turbine what does term CDP, NH, HSSOC means.
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
Describe how to use megger to measure the earth resistance and insulation resistance
How to Calibrate Ultrasonic Level Transmitter in field
What is mean by analytical instrumentation?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What are de-saturators?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
Why humidity limit is 30 to 55 % for raw material storage?
what are the values of fuel flow rate in various places in boiler.
Capacitance, resistance ( colour coding ), parallel & series circuits.
draw the block diagram of a level transmitter ?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
