what is the principale of vortex flow meter.
- 7 Answers
- 10988 Views
- Ambuja, India Glycols, I also Faced
- E-Mail Answers
Answer Posted / k.surya mutyalaro
in fluid pipe the vertices generated by the bluf body is
directly propositional to flow...and this measrement can b
in any sort , like frequency and also resistance ... the
frequency by means of ultrasonic trx and rx.... resistance
is by strain guages...but this method is better for fluids
of turbulant , for laminar flows those instrument methods r
less sensitive to respond.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
How we connect a instrument with ground, Give brief explanation with help of diagram?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
give me the formula for analog to digital converter and also d to a converter
Which is your favourite subject & explain any one topic of it.
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
How oil line flow measured?eplain about instruments used and working principle?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
List three types Level Switches with their working principles
How can a d.p. Transmitter be calibrated?
how the arrangement of equipments done in control room
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
How process line mpm calculation is done?
