Answer Posted / thirumoorthy
PH values lies between 1 to 14. if the values is in the
range of below 7,that is acitic substance,if it is greater
than 7 upto 14 that is base. Thae value is 7 that is salt.
so ph test is imporatnt in pumps
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is VCB? where it is installed at SP. What is SP?
how do we calculate length of starting time and repeated starting of a direct online starter?
Why front mounted CT polarities are always towards breaker?
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
Difference between earthing & grounding.?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
difference between high and low impedance BUS BAR relay??
what is the acceptable limit value for Desolve Gas Analysis/
how unidirectional torque is produced in DC motor?
What are the uses of stepper motor?
How to Prepare preventive maintenance shedule of machine tool.
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
how to calculate current and voltage in a same circuit?
