if dc is better then ac...then why we are perfering ac over
dc?eg:at home?
- 2 Answers
- 3786 Views
- I also Faced
- E-Mail Answers
Answer Posted / thirumoorthy
we can step up or step-down the current only in Ac not in
DC.so we are using AC supply in home or transmission systems.
and also it has low loss.
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
what is difference between speed mode and torque mode in motor?? explain in simple words please.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
what is electrical machines
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
What do you mean by phasors?
when will be the iocl interview results ifaced the interview on september 8 th
Why single phase induction motors are not self starting ?
What is voltage ratio of a transformer?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
what is active power & reactive power?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
why generator efficiency is more in swinburnes test?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
