transformers parts & function of each parts
- 25 Answers
- 395982 Views
- Amara Raja, Bhutan Ferro Alloys Limited, Breather, Electrical, Electrical Tech, ERDA, GVK, Juniper Networks, Matrix, Mechanical, NFL, Oracle, Pyramid Plastics, RPPL, RRB, Siemens, TCS, Tulip Silk Mills, I also Faced
- E-Mail Answers
Answer Posted / jils . p . johnson
1) CONSERVATOR - conservator is a type of tank , used to
help oil filling this is situated upper portion of the
power transformer . mainly these are cylindrically
shapped...
2) TANK - basically this is a container used to keep
windings(both) and cooling oil.
3) BUTCHHOLZ RELAY - this is a protecting device used to
protect our transformer windings . this is a double ended
device one end is conneced to conservator other is
connected to tank. there are two windings inside the relay
one for detecting oil level goin to empty and other is
connected to a alarm circuit for warning
4) BREATHER - Breather is a device used for absorb the
moisture content of a oil and sucked air
5) SILICA JEL - it is a chemichal matarial these are the
only one main component inside the breather basically
silica jel is a brown coloured one after the absorbtion
silica jel become pink
6) OIL LEVEL SCALE - this is a ordinary part situated on
the side of the conservator for proper oil checking oil
tank wants a specific amout of oil
7) PRIMARY WINDING - in the case of power transmission
primary windings are the main element external connection
from the power is connected to thi winding
8) SECONDARY WINDING - this is a another windin for
redusing power(in the case of step down purpos)
9) DRAIN VALVE - this valve is used for taking damaged
oil from the oil tank for the proper oil collection this
valve is situated under the oil tank
10) PORCELIN BUSH - This is a outer unit , this is used to
prevent unwanted leackage of electricity
11) RADIATOR - This device is used to cooling oil
| Is This Answer Correct ? | 286 Yes | 46 No |
Post New Answer View All Answers
What is VCB? where it is installed at SP. What is SP?
What was your role in the silicon evaluation/product ramp? What tools did you use?
2. What are the parameters of EHT sub-station?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
if we install two earth pits with a clear space of 5m without any interconnection,by checking the digital multimeter will it show continuity between earth pits? If so what would be the approx. value
What is negative sequence over voltage element?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
What difference between ref protection and differential protection ?
what is deffrence between squirral cage and wound rotor in IM?
how to find the resistance and gap volatage of the diode??
explain the types of drives
