Answer Posted / ramendra shukla
s we know there are three types of power in Electricals as-
Active, Apparant & rective.
so KVAR is stand for ``Kilo Volt Amps with Reactive
component i.e. Sin phi.
| Is This Answer Correct ? | 66 Yes | 7 No |
Post New Answer View All Answers
Explain thin film resistors and wire-wound resistors
Show the schematic arrangement of diesel power station layout and give its principle of operation.
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
what is the use of expulsition protective gap in 11Kv line.
What is meant by control system?
how current is reverse from its normal direction during the fault?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
How to address the servo drive for motor
what is the common earth
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
i am studying in final year can i allowed for 23rd UES of Indian army
why Lightening Arrester Probe sharp at Top of telecom tower.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
